Page 1 of 1

1st motion shaft/clutch/input shaft

Posted: Mon Oct 22, 2018 10:57 pm
by RichardS
Hello all,I'm looking for the above so if you have one of these for a four speed Ford gearbox kicking about I would be interested. My problem: I have a 1934 Morgan Three Wheeler F4 with a 100E engine and the input shaft is shagged, it lives on the end of a 4 foot tube that goes to the gearbox and as the tube is straight but often the car isn't is suffers. I need to find one, cut the gear bit off and weld it to a bit of steel which is then machined to fit the the tube and soft soldered in! I've resisted the temptation to buy a couple of boxes at local shows as it seemed a shame to kill a box for one component so if you have a worn out one let me know as I can use it!
Many thanks
Richard

Re: 1st motion shaft/clutch/input shaft

Posted: Mon Oct 29, 2018 5:11 pm
by LeeSample
Hi Richard. if you get stuck, I have a 4 speed box you can have for £40 ono. its located in Hitchin, Herts at the moment.

Lee

Re: 1st motion shaft/clutch/input shaft

Posted: Tue Oct 30, 2018 3:37 pm
by RichardS
Hello Lee,
Thanks for the offer, I'm in Norfolk so some distance from you but the next time I'm going to London I'll contact you to see if its possible to collet.
Thanks
Richard